Sweep or vacuum grit, squeegee winter water, clean spills promptly, use products approved for the installed topcoat, rinse residue, and inspect damage before it spreads.
Routine cleaning
Use a soft broom, dust mop, or vacuum for dry grit. For washing, follow the coating manufacturer’s cleaner and dilution guidance. Work in manageable sections so dirty solution is removed rather than allowed to dry.
A floor squeegee helps move rinse water toward a suitable drain or collection point without leaving a film.
Use a physical sample and the named system requirements to confirm the finish in your actual room.
AI-generated design concept. Not a completed company project.Spills and automotive fluids
Blot and remove spills promptly. Do not spread them across the floor with a large wet mop. Some chemicals can stain or soften a coating with long contact even when short exposure is tolerated.
Use absorbent material compatible with the spill and dispose of it according to local requirements.
Mats, tires, and storage
Wait for full cure before adding mats. Check backing compatibility, lift mats to dry the floor, and clean beneath them. Avoid dragging steel cabinets or placing sharp feet directly on the finish. Use broad compatible pads where needed.
Tire dressings and plasticizers can mark some surfaces; prevent fresh product from pooling on the coating.
Seasonal inspection
After winter, inspect thresholds, cracks, joints, and tire paths for chips, lifting, or wear. Note new moisture or concrete movement. Address local damage before water and traffic enlarge it.
Keep product, color, and installer records for future repairs. The restoration page explains when a recoat may be appropriate.
Common questions
Can I use vinegar or bleach?
Use only cleaners approved for the installed topcoat. Acids, oxidizers, high alkalinity, and solvents can change gloss, color, or surface performance.
Can I pressure-wash a coated garage floor?
Only within the product and installer guidance. High pressure at edges, joints, or damaged areas can drive water under weak sections.
Should a coated floor be waxed?
Not unless the system specifically calls for a compatible maintenance finish. Unapproved wax can create residue, change traction, and complicate recoating.
Bring the unanswered items into your inquiry
This guide is a planning aid. Ask the installer to identify the current product requirements, verify the concrete and document any unresolved condition before agreeing to the system. The references below provide context; their requirements apply to their named products or procedures.
References behind this guide
Technical limits apply to the named product or test. Confirm the current requirements for your proposed system.
